© 2010 m2k-laser, c-mount
© 2010 m2k-laser, DHP-I
© 2010 m2k-laser, DHP-F
© 2010 m2k-laser , DHP-F with different connectors
|
C-Mount
C-mount packaging with different thickness of the c-mounts is available.
All diodes are soldered on submount by hard solder followed by soft soldering of submount on c-mount.
dimensional drawings for c-mount
DHP-I/F-Mount
The DHP mount can be ordered in several stages. The DHP-inset (DHP-I) offers a better heat dissipation
by a bigger gold coated copper block in comparison to c-mount designs. The DHP-I mount is fixed
by two screws on the left and right hand sides of the copper block whereas the c-mount design offers
only a srew hole directly below the chip.
dimensional drawings for DHP-Inset
The DHP-inset can be fixed in the DHP-frame (DHP-F-option). This package offers a good stability and protection of the chip.
Also the connections of the diode are already fixed.
In addition different pre-attached electrical connectors are available.
dimensional drawings for DHP-Frame
"p-side-down" - contact
"p-side-up" - contact
|
